Filter
Top Products
GETTING STARTED[ 18 ] www.uniden.com
1) When the phone is in standby mode, press and hold the
caller id/menu key. The following screen appears.
2) Press the vol/ / key three times to select
Dial.
3) Press the select/channel key to toggle between
Tone and
Pulse.
4) Press the end keyand return the handset to the main base unit to complete the
setting. The handset returns to standby mode.
Setting the language
There are three languages to choose from; English, French and Spanish.
1) When the phone is in standby mode, press and hold the
caller id/menu key. The following screen appears.
2) Press the vol/ / key four times to select
Language.
3) Press the select/channel key to toggle between
Eng, Fr. and
Esp.
4) Press the end key or return the handset to the main base unit or charging cradle
to complete the setting. The handset returns to standby mode.
•Dialing mode can only
be changed from
handset 1. To confirm
which handset is HS1,
look at the display
indicating HS1 or
HS2.
• If you are not sure of
your dialing system,
set for tone dialing.
Make a trial call. If the
call connects, leave the
setting as is. Otherwise
set for pulse dialing.
• If your phone system
requires pulse dialing
and you need to send
the DTMF tones for
certain situations
during a call, you may
switch over to tone
dialing. (Refer to "Tone
Dialing Switch-over" on
page 21.)
Choosing the dialing mode
Most phone systems use tone dialing which sends DTMF tones through the phone
lines. However, some phone systems (such as those in rural areas) still use pulse
dialing. The default setting is tone dialing. Depending on your dialing system, set
the mode as follows:
UC427ZH (DXI986-2) 10/20/03 10:52 AM Page 18