Filter
Top Products
GETTING STARTED [ 13]www.uniden.com
C. Connect the main base unit and charging
cradle
1) Connect each AC adapter to the DC IN 9V jack
and to each standard 120V AC wall outlet.
2) Set the main base and charging cradle on a
desk or tabletop, and place one handset in
the main base unit and one in the charging
cradle.
3) Make sure that the charge/in use and charge LED
illuminate.
If the LED does not illuminate, check to see that the AC
adapter is plugged in and the handset makes good contact
with the cradle's charging contacts.
• Place the power cord
so that it does not
create a trip hazard or
where it could
become chafed and
create a fire or
electrical hazard.
• Use only the
supplied AD-0001
AC adapters.
Do not use any other
AC adapters.
• Connect each AC adapter to each continuous power supply.
•Place the main base unit and charging cradle close to the AC outlets so that you can unplug the AC
adapters easily.
Route the corRoute the cord.d.Route the cord.
• After installing the battery packs in the handsets, charge your handsets at least 15-
20 hours before plugging into the phone line
.
4) Once the handset battery packs are fully charged, connect the
telephone line cord to the
TEL LINE jack and to a telephone
outlet.
Modular
If your telephone outlet isn't modular,
contact your telephone company
for assistance.
GETTING STARTED
UC427ZH (DXI986-2) 10/20/03 10:52 AM Page 13