Filter
Top Products
ADDITIONAL INFORMATION[ 40 ] www.uniden.com
Changing the Digital Security Code
The digital security code is an identification code used to connect each handset and
the main base unit. Normally, setting the code is not necessary. The first time you
charge each handset in the main base, the security code is automatically set.
In the rare situation that you suspect another cordless telephone is using the same
security code, you can change the code.
1) Remove the handset from the main base unit or charging cradle. Press and hold
the find hs key on the main base.
2) While holding the find hs key, place the handset in the main base unit, and leave
the handset on the main base for more than 3 seconds. A new random security
code is set.
Installing the Beltclip
To attach the beltclip
Insert the beltclip into the holes on each side of the handset. Press down until it clicks.
To remove the beltclip
Pull both sides of the beltclip to release the tabs from the holes.
•To protect you against
misbilled calls which
might result from your
phone being activated
by other equipment, the
cordless phone provides
AutoSecure
TM
(which
electronically locks your
phone when each
handset is in the main
base or charging cradle)
and Random Code
TM
digital security (which
automatically selects
one of over 262,000
digital security codes
for each handset and
main base).
• If the handset battery
pack is completely
discharged or the
battery pack is
removed, the digital
security code will be
lost. If this happens, a
new security code is set
automatically the next
time the battery pack is
charged.
You can change the phone’s digital security code on either handset. However, you must
re-register the other handset (not used to change the digital security code) back to the
main base unit. See registration on page 14.
UC427ZH (DXI986-2) 10/20/03 10:53 AM Page 40