Filter
Top Products
51
52
Using the Answering
System
To operate from a remote location, use any touch-tone telephone, and follow these steps:
Call your telephone number and wait for the system to answer. If the answering system is off, it will answer after
about ten rings and sounds a series of beeps.
During the greeting or the beeps (if answering system is off), press
[0] and enter your security code/PIN within
two seconds.
The answering system announces the current time and the number of messages stored in memory.
You hear “To play incoming messages, press zero-two. For help, press one-zero” followed by a beep.
Enter a remote command from the chart below. You have fteen seconds to enter the rst command; after the
rst command, you have two seconds to enter each command.
Remote Commands
Command Function Command Function Command Function
[0] then [1] Repeat a message* [0] then [4] Delete a message [0] then [9] Answering system off
[0] then [2] Play incoming messages [0] then [5] Stop operation [1] then [0] Help
[0] then [3] Skip a message [0] then [6] Answering system on
* If you press
[0] then [1] in the rst four seconds of a message, the system skips to the previous message.
If you press
[0] then [1] after the rst four seconds of a message, the system repeats the current message.
When you nish, you will hear intermittent beeps indicating that the system is in the command waiting mode.
Enter another command from the chart within fteen seconds.
Hang up to exit the system. The answering system automatically returns to its normal standby setting.
1)
2)
3)
4)
5)
6)