Filter
Top Products
40
Using Hold, Conference
and Transfer
Finding a Lost Handset
To locate a misplaced handset, press [Int’com] on the base when the phone is in standby. Use [ ] or [ ] to
select the handset you want to page, and then press
[Menu/Select]. Select ALL to page all registered handsets.
To cancel paging, press
[Int’com] on the base again.
Note: Handsets that are not currently connected to this base will not be paged.
Using Hold, Conference and Transfer
Placing a Call on Hold
During a call, press [Clear/Int’com] on the handset or [Int’com] on the base to place the caller on hold. If you
leave a caller on hold for more than ten seconds, the display screen will read, Line On Hold.
To return to the party on hold, press
[ /Flash] or [ ] on the handset or [ ] on the base. The phone will return
to the holding party.
Notes: • You can only place a caller on hold for ve minutes. Once ve minutes has passed, that party’s line will be
disconnected and the phone will return to standby.
• While a call is on hold, Caller ID and Call Waiting cannot be received.
Conferencing
If you have more than one handset, up to four people can participate in a conference call. A four-way conference call
consists of an outside line, two handsets, and the base speakerphone. You can easily join a call already in progress.
The handsets must be currently connected to the same base (see page 25).
Press
[ /Flash] or [ ] on the handset or [ ] on the base to join the call.
To hang up, return the handset to the cradle or press
[ ] on the handset or [ ] on the base. The other party
will still be connected to the call.
1)
2)
1)
2)
Finding a Lost Handset
Using Hold, Conference and Transfer