Filter
Top Products
Intercom User Station US2002 - 9
Figure 2. Locations of Configuration Jumpers and Switches
Installation
Unpacking
The package contains the following items. Contact the shipper or your Audiocom dealer immediately
if anything is damaged or missing. Detach and fill out the registration card and return it to Telex to
properly register your US2002.
Configuration Pre-check
Before connecting the US2002 make sure that it is properly configured for your intended usage.
Figure 2 shows the locations of the configuration jumpers and switches. To access internal switches
and jumpers, remove one screw from the top cover and three screws from each side. Note, that
switch SW2 can be accessed through the back panel.
☞If you change any switch settings while the US2002 is operating, you must perform a
reset: either cycle power off then on, or simultaneously press the All Talk and Listen 1 keys,
then release them. The sidetone controls are adjusted after power-up and are normally
accessed through the bottom cover.
ytitnauQytitnauQ
ytitnauQ
ytitnauQytitnauQ noitpircseDnoitpircseD
noitpircseD
noitpircseDnoitpircseD
1noitatSmocretnI2002SU
1dracnoitartsigerdnaytnarraW
1launaMresU
42002SUehtfoesupotksedrofteefrebbuR
1)42egap,31erugiF(snoitacilppalaicepsrofgulpnoitanimreT