Filter
Top Products
10
Sony Personal Entertainment Organizer PEG-TJ37/TJ27 US A-BTH-100-11 (1)
Troubleshooting
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
My CLIÉ handheld does not work
properly
B Is the POWER/HOLD switch of your CLIÉ handheld in HOLD mode?
Your CLIÉ handheld does not work when the POWER/HOLD switch is in
HOLD mode. Make sure you release HOLD mode.
Note
When HOLD mode is active, if you try to turn on your CLIÉ handheld using the Applications
or CAPTURE buttons, or the Lens Cover Lever, the POWER LED blinks 3 times, but the
power is not turned on.
B Has the battery power of your CLIÉ handheld run out?
Connect your CLIÉ handheld to the AC power adapter with the plug
adapter, then allow it to be charged for a few minutes before turning it on. If
it turns on, continue charging for approximately four hours and then perform
a soft reset.
B Is the connector between your CLIÉ handheld and the plug adapter dirty?
You cannot charge your CLIÉ handheld if the connector is dirty. Connect
and disconnect your CLIÉ handheld and the plug adapter several times to
clean the connector.
B Perform a soft reset by pressing the RESET button at the back of your CLIÉ
handheld.
b
For details, refer to “Basic operations of your CLIÉ
™
handheld: Restarting your
CLIÉ
™
handheld” in the supplied “Read This First (Operating Instructions)”.
B Is the POWER/HOLD switch of your CLIÉ handheld in HOLD mode?
The screen is not displayed when the POWER/HOLD switch is in HOLD
mode. Make sure you release HOLD mode.
I cannot turn on my CLIÉ handheld
The screen is not displayed even though the POWER
LED is on
01US01COV.book Page 10 Monday, December 8, 2003 11:33 AM