Filter
Top Products
Synchronizing a transmitter with the receiver
29
Synchronizing a transmitter with the receiver
When synchronizing a transmitter with a receiver, please observe the following:
̈ Only use a transmitter and a receiver from the same frequency range (see the type plate
on the transmitter and the receiver).
̈ Make sure that the desired frequencies are listed in the enclosed frequency information
sheet.
̈ Make sure that the desired frequencies are approved and legal in your country and, if
necessary, apply for an operating license.
Synchronizing a transmitter with the receiver – individual operation
Upon delivery, transmitter and receiver are synchronized with each other. However, if you
cannot establish a transmission link between transmitter and receiver, you have to synchro-
nize the channels of the devices:
̈ With the receiver, perform a frequency preset scan to scan the frequency banks for
unused channels (“Scan New List”, see page 21).
̈ Select a channel on your receiver (“Current List”, see page 21).
The receiving frequency of the channel must be approved and legal in your country
(see above).
̈
Synchronize a transmitter with the receiver via the infra-red interface (
see
page 14).
This establishes a transmission link between the transmitter and the receiver.
Alternatively, you can set the channel on the transmitter manually:
̈ Make sure that you set the transmitter to the same frequency bank and the same channel
as the receiver.
For information on the setting options of the transmitter, refer to the instruction manual
of the transmitter.
Synchronizing transmitters with receivers – multi-channel operation
Network operation
In multi-channel operation, the receivers are remote controlled via a PC running the “Wireless
Systems Manager” (WSM) software.
̈ Connect the receivers in a network (see page 12).
̈ Launch the “Wireless Systems Manager” (WSM) software.
̈ To scan for unused receiving frequencies and to configure the receivers, proceed as
described in the instruction manual of the “Wireless Systems Manager” (WSM) software.
̈ Set the corresponding transmitter to the selected frequency bank and to the selected
channel either by synchronizing the transmitter with the receiver (
see page 14
) or by
setting the frequency bank and the channel manually (see the instruction manual of the
transmitter).
Your multi-channel system is now set up.
WSM
543.200
B.Ch: 20.64
PEAK
MUTE
EQ:
+ 12dB
P
-10
040
30
20
10
-20
-30
-40
AF
RF
MHz
True Diversity Receiver EM 2000
**2000**
SKM2000
543.200
B.Ch: 20.64
PEAK
MUTE
EQ:
+ 12dB
P
-10
040
30
20
10
-20
-30
-40
AF
RF
MHz
True Diversity Receiver EM 2000
**2000**
SKM2000
543.200
**2000** **2000**
B.Ch: 20.64
PEAK
MUTE
EQ:
+ 12dB
P
-10
040
30
20
10
-20
-30
-40
AF
RF
MHz
543.200
B.Ch: 20.64
PEAK
MUTE
EQ:
+ 12dB
P
-10
040
30
20
10
-20
-30
-40
AF
RF
MHz
True Diversity Receiver EM 2050
SKM2000 SKM2000
Advantages of controlling the receivers via the “Wireless Systems Manager” (WSM)
software:
• Detailed overview of all receiving channels
• Remote control of all receivers in the network
• Combination of receivers of different frequency ranges (see page 4).