Filter
Top Products
Adjusting settings via the operating menu
23
Getting into the extended menu “Advanced Menu“
To get into the extended menu “Advanced Menu” (see page 23):
̈ From the main menu, select “Advanced”.
The extended menu “Advanced Menu“
Setting the receiving frequencies and the frequency banks “U1” to “U6
Via the “Tune” menu item, you can set a receiving frequency to be stored in the current
channel or you can select a different channel and assign it a receiving frequency.
Setting a receiving
frequency for the
current channel
̈ Set the desired frequency.
Selecting a channel and
assigning this channel
afrequency
Squelch
Easy Setup Setup
Frequency Preset
Name
AF Out
Equalizer
Auto Lock
Advanced
Exit
Menu
Tune
Guitar Tuner
Sync Settings
Pilot Tone
Warnings
LCD Contrast
Factory Reset
IP-Address
Software Revision
Exit
Advanced Menu
When you have selected one of the system banks and then select the “Tune” menu,
the receiver automatically switches to channel 1 of the frequency bank “U1”. In this
case, “U1.1” briefly appears on the display panel.
Upon delivery, the channels of the frequency banks “U1” to “U6” are not assigned a
receiving frequency.
̈ Turn the jog dial until the “Tune” menu item appears.
̈ Press the jog dial
.
The frequency selection appears.
It is vital to observe the notes on frequency selection on page 29.
̈ Press the jog dial.
Your settings are stored. The “Tune” menu item appears.
Select “Tune” Select the MHz value
and confirm
Select the kHz value;
store the setting
Advanced Menu
543.200 MHz
Tune
B.Ch: U1. 1
543.200MHz
Tune
B.Ch: U1. 1
548.200 MHz
Exit
Tune
Sync Settings
“Stored”
PEAK
-10
0
40
30
20
10
-20
-30
-40
AF
RF
PEAK
-10
0
40
30
20
10
-20
-30
-40
AF
RF
PEAK
-10
0
40
30
20
10
-20
-30
-40
AF
RF
̈ Turn the jog dial until the “Tune” menu item appears.
̈ Keep the jog dial pressed until the frequency bank selection appears.