Filter
Top Products
Using the receiver
14
̈ Set the headphone volume control » to the minimum position.
̈ Connect headphones with a ¼” (6.3 mm) stereo jack plug to the headphone output ·.
̈ Gradually increase the volume and monitor the audio signal with the lowest possible
volume.
Synchronizing a transmitter with the receiver
You can synchronize a suitable transmitter of the 2000 series with the receiver. By default,
the following parameters are transferred to the transmitter during synchronization:
To transfer the parameters:
̈ Switch the transmitter and the receiver on.
̈ Press the button ¿ on the receiver.
“Sync” appears on the display panel of the receiver.
̈ Place the infra-red interface of the transmitter (see the instruction manual of the trans-
mitter) in front of the infra-red interface of the receiver´.
The parameters are transferred to the transmitter. When the transfer is completed, “ ”
appears on the display panel. The receiver then switches back to the current standard
display.
To cancel the transfer:
̈ Press the STANDBY button º on the receiver.
“ ” appears on the display panel of the receiver. “ ” also appears if:
– no transmitter was found or the transmitter is not compatible,
– no transmitter was found and the synchronization process was canceled after
30 seconds,
– you canceled the transfer.
Deactivating the lock mode temporarily
You can activate or deactivate the automatic lock mode via the “Auto Lock” menu item (see
page 22). If the lock mode is activated, you have to temporarily deactivate it In order to be
able to operate the receiver:
B.Ch:
PEAK
EQ:
+ 1
P
-10
0
40
30
20
10
-20
-30
-40
AF
RF
True Diversity Receiver EM 2000
·
»
Setting Transferred parameters
“Frequency Preset” Currently set frequency
“Name” Freely selectable name currently set on the receiver
“Pilot Tone” Current pilot tone setting of the receiver (“Inactive”/“Active”)
Via the “Sync Settings” submenu, you can adjust additional parameters to be
transferred to the transmitters (see page 26).
¿
´
¿
´
̈ Press the jog dial or the STANDBY button.
“Locked” appears on the display panel.
̈ Turn the jog dial.
“Unlock?” appears on the display panel.
̈ Press the jog dial.
– When you are in the operating menu, the lock mode remains deactivated until
you exit the operating menu.
– When one of the standard displays is shown, the lock mode is automatically
activated after 10 seconds.