Filter
Top Products
Using the receiver
13
Using the receiver
To establish a transmission link, proceed as follows:
1. Switch the receiver on (see below).
2. Switch the transmitter on (see the instruction manual of the transmitter).
The transmission link is established and the display backlighting of the receiver changes
from red to orange.
If you cannot establish a transmission link between transmitter and receiver:
̈ Make sure that transmitter and receiver are set to the same frequency.
̈ If necessary, read the chapter “If a problem occurs ...” on page 31.
Switching the receiver on/off
To switch the receiver on:
To switch the receiver to standby mode:
̈ If necessary, deactivate the lock mode (see page 14).
To completely switch the receiver off:
̈ Disconnect the receiver from the mains by unplugging the mains cable plug from the wall
socket.
The backlighting of the STANDBY button º goes off.
Monitoring the audio signal via headphones
You can monitor the audio signal via the headphone output.
It is vital to observe the notes on frequency selection on page 29.
.200
UTE
MHz
**2000**
SKM2000
º
̈ Briefly press the STANDBY button.
The receiver switches on and the “Receiver Parameters” standard display
appears.
̈ Keep the STANDBY button pressed until “OFF” appears on the display panel.
The integrated antenna splitter and the booster supply voltage remain active so
that the antenna signals are still looped through to daisy-chained receivers.
• When in the operating menu, pressing the STANDBY button º will cancel your
entry (ESC function) and return you to the current standard display.
•The STANDBY button º is backlit in red both during operation and in standby
mode.
CAUTION! Danger of hearing damage!
Listening at high volume levels for long periods can lead to permanent hearing defects.
̈ Set the headphone volume control » to the minimum position before putting the head-
phones on.