Filter
Top Products
Putting the receiver into operation
12
Connecting an amplifier/mixing console
The receiver’s XLR-3M socket ¹ and the ¼” (6.3 mm) jack socket ¸ are connected in parallel.
̈ Use a suitable cable to connect the amplifier and/or the mixing console to the XLR-3M
socket ¹ and/or the ¼” (6.3mm) jack socket ¸ (see also page 34).
̈ Via the operating menu, adjust the audio output level (“AF Out”) of the receiver to the
input of the amplifier or mixing console (see page 17). The audio output level is adjusted
via the operating menu and is common for both sockets.
Connecting receivers in a network
You can connect several receivers in a network. The receivers are remote controlled via a PC
running the “Wireless Systems Manager” (WSM) software. This software will assist in the
quick and safe configuration of multi-channel systems.
For further information on multi-channel operation, visit the corresponding product page on
our website at www.sennheiser.com.
̈ Use standard network cable (at least Cat 5) to connect the receivers via the LAN socket ƹ
to an Ethernet switch. Connect a computer to the Ethernet switch (see diagram).
When a receiver is properly connected to the Ethernet switch or the computer, the yellow
LED Ƹ
at the rear of the receiver lights up.
Connecting the mains cable
̈ Pass the mains cable through the cable grip µ.
̈ Connect the mains cable to the mains socket ¾.
̈ Plug the mains plug into the wall socket.
+18dBu MAX ETHERNET RJ-45
B
TRANS-BAL
AF OUT B
¸
¹
WSM
543.200
B.Ch: 20.64
PEAK
MUTE
EQ:
+ 12dB
P
-10
040
30
20
10
-20
-30
-40
AF
RF
MHz
True Diversity Receiver EM 2000
**2000**
SKM2000
543.200
B.Ch: 20.64
PEAK
MUTE
EQ:
+ 12dB
P
-10
040
30
20
10
-20
-30
-40
AF
RF
MHz
True Diversity Receiver EM 2000
**2000**
SKM2000
543.200
**2000** **2000**
B.Ch: 20.64
PEAK
MUTE
EQ:
+ 12dB
P
-10
040
30
20
10
-20
-30
-40
AF
RF
MHz
543.200
B.Ch: 20.64
PEAK
MUTE
EQ:
+ 12dB
P
-10
040
30
20
10
-20
-30
-40
AF
RF
MHz
True Diversity Receiver EM 2050
SKM2000 SKM2000
The EM 2050 twin receiver has a separate LAN socketƹ for each receiver.
CAUTION! Damage due to electric current!
If you connect the receiver to an unsuitable power supply, this can cause
damage to the device.
̈ Use the supplied mains cable to connect the receiver to the mains (100 to
240 V AC, 50 or 60 Hz).
̈ Ensure a reliable mains ground connection of the receiver – especially
when you are using multi-outlet power strips or extension cables.
50/60Hz 0.25A
100 - 240V
¾
µ