Sennheiser 2015 Two-Way Radio User Manual


 
95
̈
To release individual channels, select the desired channel by using the
̆
/
̄
rocker button (UP/DOWN). (By briefly pressing the button, the
display jumps either forwards or backwards to the next channel; by hol-
ding down the button, the display cycles continuously.)
Note:
You can display the frequency stored in the selected channel. To do so,
press the
SET
button and the
̆
button (UP) simultaneously.
̈
Briefly press the
SET
button. The selected channel can now be accessed
by the user. “ACCESS” briefly appears on the display and the display
then displays the next channel that can be released.
̈
Have you released all required channels as described above? Store your
settings by pressing the
SET
button until “STORED” appears on the dis-
play.
Selecting the frequencies to be stored in the channel bank “U”
TUNE
Via the “
TUNE
” menu, you can select the frequencies to be stored in the
channel bank “U” (user bank). When selecting the “
TUNE
” menu, the trans-
mitter or receiver automatically switches to the channel bank “U”.
Note:
Always assign the same frequency to the same channel on both trans-
mitter and receiver.
̈
Use the
̆
/
̄
rocker button (UP/DOWN) to select the channel for which
you want to set the frequency.
̈
Press the
SET
button to confirm your selection.
The currently set fre-
quency is displayed.
̈
Use the
̆
/
̄
rocker button (UP/DOWN) to select the desired transmis-
sion or receiving frequency. The frequencies are tunable in 25-kHz
steps within a switching bandwidth of 36 MHz max. For intermodula-
tion-free frequencies, please refer to the enclosed frequency table.