70
Connecting audio sources to the transmitter
You can connect audio sources such as a CD player, a television, or the sound
card of a computer to the line input of the transmitter.
̈
Connect the 3.5 mm jack plug of the connecting cable to the transmit-
ter’s 3.5 mm jack socket (LINE)
ᕡ
.
̈
Via the operating menu, adjust the sensitivity of the line input (see
“Adjusting the sensitivity of the line input“ on page 82).
Note:
If the transmitter is preset so that the line input is switched off, the dis-
play for line level is not shown on the display panel.
Connecting the receiver to hearing aids or headphones
Connecting the receiver to hearing aids with direct audio input
̈
Connect a hearing aid with direct audio input to the receiver’s 2.5 mm
jack socket (LOW)
ᕢ
. Suitable connecting cables (see “System variants
and accessories“ on page 103) are available from your Sennheiser dea-
ler.
Connecting the receiver to a hearing aid without audio input
(hearing aid must have Telecoil)
̈
Connect the EZT 2015 induction neck loop or the EZI 120 induction
couplers for hearing aids without audio input to the receiver’s 3.5 mm
jack socket (HI)
ᕡ
. Suitable connecting cables for the induction coup-
lers (see “System variants and accessories“ on page 103) are available
from your Sennheiser dealer.
Connecting the headphones
You must only connect headphones with a stereo jack plug and a minimum
impedance of 32
Ω
to the receiver (see “Connector assignment“ on
page 102).
̈
Connect the headphones to the receiver’s 3.5 mm jack socket (HI)
ᕡ
.
ᕡ
³ ·