85
If problems occur that are not listed in the above table or if the problems cannot be solved with the pro-
posed solutions, please contact your technical expert for assistance.
Recommendations and tips
... for system planning
y
Transmitter and receiver of a transmission link must be set to the same frequency.
y
A transmitter can be received by several receivers on the same frequency.
y
However, a receiver cannot receive several transmitters on the same frequency. Incorrect settings are
indicated by crackling and chirping in the receiver.
... for the MKE 2015-0 plug-on microphone (optional accessory)
y
Adjust the length of the neck strap so that the distance between the microphone and your mouth is
9.8 inches at the most.
y
The plug-on microphone allows you to transmit group discussions. For this purpose, place the trans-
mitter on the table on a soft and springy pad.
... for the ME 2015-H headset microphone (optional accessory)
y
Always use the microphone with a popshield and position the microphone at the corner of the mouth.
y
You can vary the bass reproduction by increasing/decreasing the talking distance.
y
Make sure that the sound inlet is directed towards the mouth. The sound inlet is marked with a little
dot.
... for the SK 2015 transmitter
y
Make sure that the antenna and the microphone cable do not cross.
y
For best results, make sure that the transmitter sensitivity is correctly adjusted.
No access to a certain
channel
The channel has not been released. Set transmitter and receiver to a
different channel.
The technical expert must release the
channel.
Problem Possible cause Possible solution