Filter
Top Products
Installation
9
ON A WALL PLATE OR WALL
To mount the phone directly on a wall, you need
two screws (not supplied) with heads that fit into
the keyhole slots on the base and the bracket.
Drill two holes 3
15
/16 inches apart. Thread a
screw into each hole, letting the heads extend
about
1
/8 inch. Ô
1. Remove the bracket
from the base and
snap it into the
notches on the
bottom of the base.
2. Plug one end of the
supplied modular
cord (short for a wall
plate, long for direct
wall mounting) into
the
TEL LINE jack on the base’s back.
3. Plug the supplied AC adapter's barrel plug
into the
DC IN 9V jack.
4. Route the adapter
and modular cords
through the
bracket’s grooves.
5. For a wall plate,
align the base and
the bracket's
keyhole slots with
the wall plate studs
and slide the base
downward to secure it.
For direct wall
mounting, align the
base and the
bracket's keyhole
slots with the
mounting screws
and slide the base
downward to
secure it.
Ô NOTE Ô
If the base unit is mounted
on the wall, always put the
handset in the base with
the CID display facing
forward to make sure the
handset does not fall out of
the base.