Filter
Top Products
Additional Information
29
Select the phone number to be stored from
the Caller ID list by pressing
RING/VOL/+ or
RING/VOL/-.
2. Press
MEM.
3. Press RING/VOL/+ or RING/VOL/- or enter a
number (
0 - 9) to select the memory location
to be stored.
4. Press
SELECT. Ô
You hear a confirmation tone, and the
number is stored in memory. The display
returns to the Caller ID list.
ADDITIONAL
INFORMATION
INSTALLING THE BELTCLIP
To attach the beltclip
Insert the beltclip into the holes on each side of
the handset. Press down until it clicks.
To remove the beltclip
Pull both sides of the beltclip to release the tabs
from the holes.
HEADSET INSTALLATION
You can connect an optional headset with a
3
/32-
inch (2.5-mm) plug. Contact RadioShack for a
suitable headset.
To connect the headset, open the rubber cover
on the side of the handset. Then insert the
headset’s plug into the jack.
Ô
When you finish using the headset, disconnect it
from the handset and close the rubber cover to
protect the jack.
Ô NOTES Ô
Storing Caller ID Messages
in Memory Dialing
If a message has already
been stored in the selected
memory number location, a
confirmation screen is
displayed.
Press RING/VOL/+ to
select ¨Yes¨. Press
SELECT to overwrite.
The display returns to the
Caller ID list.
Headset Installation
• If you place the handset
on the base to recharge
it while the headset is
connected, be sure the
handset seats properly.
• You can use a handset
holder (available from
your local RadioShack
store) to hang the
handset on your belt for
greater convenience
when using a headset.