Filter
Top Products
Installation
10
6. Plug the adapter into a standard AC outlet.
And plug the modular cord’s other end into a
modular phone line jack.
7. Raise the antenna to a vertical position.
SETTING THE VISUAL RINGER
BRIGHTNESS
The VISUAL RINGER switch allows you to set the
brightness of the visual ringer LED on the base.
There are three options to choose from: HIGH,
LOW and OFF. If you set the switch to off, visual
ringer LED never flashes.
CONNECTING/CHARGING THE
BATTERY PACK
The phone comes with a rechargeable nickel-
cadmium battery pack in the handset, but not
connected. Before using your phone, you must
connect the battery pack. Then charge it for
about 15
–20 hours.
!
1. Press down and slide off the battery
compartment cover.
2. Lift the battery pack out of the compartment.
3. Plug the battery pack’s connector into the
socket in the compartment (the connector fits
only one way). Then place the battery pack in
the compartment.
4. Replace the cover.
To charge the battery pack, place the handset on
the base. The
CHARGE/IN USE indicator on the
base lights.
!
!
IMPORTANT
!
The EPA certified
RBRC
®
Battery
Recycling Seal on
the nickel-cadmium
(Ni-Cd) battery indicates
RadioShack is voluntarily
participating in an industry
program to collect and recycle
these batteries at the end of
their useful life, when taken out
of service in the United States
or Canada. The RBRC program
provides a convenient
alternative to placing used Ni-
Cd batteries into the trash or the
municipal waste stream, which
may be illegal in your area.
Please call 1-800-THE-SHACK
(1-800-843-7422) for
information on Ni-Cd battery
recycling and disposal bans/
restrictions in your area.
RadioShack’s involvement in
this program is part of the
company’s commitment to
preserving our environment and
conserving our natural
resources.
!
IMPORTANT
!
Be sure the battery pack is
properly connected before
you try to charge it. The
CHARGE/IN USE indicator
lights when the handset is on
the base, even if the battery
pack is not connected.