Filter
Top Products
77
Beyond the Basics
Setting the Number of Rings
The ring time setting allows you to set the number of
rings the caller hears before your answering system
plays the outgoing message. You can set the ring
time to answer after two, four, or six rings. If you
enable the Toll Saver (TS) setting, the answering
system picks up after two rings if you have new
messages, and after four rings if there are none. This
way, if you make a long distance call to check your
messages, you can hang up after the second ring to
avoid long distance billing charges.
From the base From the handset
Press MENU/CLOCK
three times. The base
displays the current
number of rings (2, 4,
6, or TS for toll saver)
and announces the
setting.
Press
/select or
/select until the
desired ring time
appears.
Press SET. A
confi rmation tone
sounds, and the
system announces
the new ring time.
1.
2.
3.
Press MENU/CLEAR.
Select the ANSW.
SETUP menu, and
then the RING TIME
submenu.
Move the cursor to
select a ring time
(TOLL SAVER, 2
TIMES, 4 TIMES, or 6
TIMES).
Press SELECT/
.
You will hear a
confi rmation tone.
1.
2.
3.
UP410BH(43-5829)OM.indb 77UP410BH(43-5829)OM.indb 77 1/23/2006 6:32:23 PM1/23/2006 6:32:23 PM