Filter
Top Products
Chapter 3-Basic Operation
3-6
RMX Management
The RMX Management pane lists the parameters that need to be
configured to set up and run conferences.
The Configuration Pane is divided into two sections:
• Frequently Used – parameters often configured monitored or
modified.
• Rarely Used – parameters configured during initial system set-up
and rarely modified afterward.
Only administrators can modify these parameters.
Status Bar
The Status Bar at the bottom of the RMX screen contains System and
Participant Alerts tabs as well as a Port Usage Gauge and an MCU State
indicator.
System Alerts
This is a list of system problems. The alert indicator flashes red when at
least one system problem exists. The flashing continues until an operator
or administrator reviews the list.
Open the System Alerts pane by clicking the System Alerts button in the
left corner of the Status Bar.
For more information about Active Alarms and Faults List, see the RMX
2000 Administrator’s Guide, "System and Participant Alerts” on page 11-1.
Close the System Alerts pane by clicking the System Alerts button again.
Viewing Permissions
Chairperson
Administrator
Operator
D
D
Viewing Permissions
Chairperson
Administrator
Operator
D
D
Active
Alarms
Faults
List