Filter
Top Products
PLANET VIP-150T User’s Manual
35
4.11 [flash] command
This command will clean the configuration stored in the flash rom to default value and
reboot the VIP-150T.
?
Note:
1. After user upgrade new software version, suggested to execute this
command to make sure new software work well on VIP-150T.
2. To execute the command flash –clean, all configuration of VIP-
150T
stored in flash will be cleaned. It is authorized for the user whose login
name is “root” only.
4.12 [sysconf] command
1. -print: display all current configurations.
2. -idtime: set the duration(in second) of two pressed digits in dial mode as timed out.
If after the duration user hasn’t pressed next number, VIP-150T will dial out all
number pressed.
3. -keypad: set DTMF type .User can select DTMF type VIP-150T receive and
transmit.(sysconf –keypad 0/1 , 0 for in band ,1 for RFC2833.)
4. -2833type: change RFC2833 Payload type.
5. -eod: select end of dialing key, e.g. set end of dial key as “＊” button , after finished
pressing dialing number then press “＊” will dial out. (sysconf –eod 0/1/2 , 0 for no
end of dial key , 1 for “＊” button, 2 for “#” button )