Filter
Top Products
PLANET VIP-150T User’s Manual
7
Chapter 2 Configuring the VIP-150T through
LCD Phone menus
?
Note:
1. After any configuration is made for the VIP-150T, user has to do Reboot
in
the selection 7 “Reboot”.
2. We suggest user to set IP address via LCD menu 5→
2.3.4.5 first, then
go to chapter 3 to do other detail configurations via web browser.
2.1 Initialize VIP-150T
1. When power on the VIP-150T, the LCD screen shows as below. Now VIP-150T is
running Boot sector program.
2. When VIP-150T finishes boot program initialization. User can see flashing greeting
as below:
3. Then VIP-150T get into standby mode:
The main LCD screen would be shown as similar as above. “Proxy” means the
VIP-150T is in Proxy Mode, and when VIP-150T is connected to SNTP server, on
LCD will show current time captured from SNTP server.
4. When VIP-150T is under peer-to-peer mode, on LCD will show “P2P” instead of
“Proxy”.
5. After pressing the PSTN button, the “Proxy” or “P2P” will be replaced by “PSTN”.
Please notice that user must plug PSTN line in RJ-11 port when VIP-150T is in PSTN
VIP-150T
Board Start Booting
System Initializing…………..
VIP-150T
Proxy 10:10:10 AM
VIP-150T
P2P 10:10:10 AM