Filter
Top Products
PLANET VIP-150T User’s Manual
11
(3) Auto Re-connect
Choose ON or OFF to enable or disable this function. If user enables this
function, after PPPoE disconnected, VIP-150T will automatically reboot to
re-connect, and after reboot, if VIP-150T still can’t connect with server,
VIP-150T will keep trying to connect. On the other hand, if user disables
this function, VIP-150T won’t reboot and keep trying to connect.
8. SNTP Configuration
(1) SNTP Mode:
User can set SNTP function to be on or off, which means VIP-150T will
capture current time from SNTP server or not.
(2) SNTP Server:
User can specify a SNTP server for VIP-150T to capture current time.
(3) Time Zone:
User can set time zone via pressing ç or è according to the location
VIP-150T is. For example, in Taiwan the time zone should be set as
GMT+8:00.
9. Behind IP-Sharing
(1) If VIP-150T is behind IP sharing or NAT device, on IP sharing must
enable “DMZ” function or set “Virtual Server” to open ports (UDP port:
5060 and 16384).
(2) User must enter public IP address of IP sharing.
6. Advanced Settings (protected by password)
l Please Enter Password: (**)
User must key in password to enter this menu, selections under this
command are all important ones, which can only be configured by advanced
users.
?
Note:
1. Default Password to enter is empty, please press OK to enter sub-menus.
2.
If user forget password, please contact with your distributor, we will
generate a specific password according to your MAC address of
VIP-150T.
3. User can also try to configure VIP-
150T via Telnet or Web browser with
default IP address: 192.168.0.1
1. SIP Settings
(1) Connect Mode