Filter
Top Products
System configuration
40
2.4 Locking and unlocking the keypad
You can lock the keypad in order to avoid the keys from being pressed inadvertently.
E.g., when you keep the handset in your pocket.
• to lock the keypad
press the key for 2 seconds,
• to unlock the keypad
press the key for 2 seconds.
• Or go to the "SETTINGS" menu, then to the "Handset settings" sub-menu
and select "Keypad lock", in order to activate this function.
2.5 Selecting the Babysit mode
This enables you to hear any noise in a monitored room other than the one you are in.
Go to the "SETTINGS" menu, then to the "Handset settings" sub-menu and
select "Babysit mode". In "standby mode", the screen displays "BABYSIT".
: When activated, the monitoring handset does not ring for an incoming call
and beeps are deactivated (see “Selecting the room monitor (Babysit mode)”,
page 29).
2.6 Selecting the base station
Although a handset can be subscribed to up to 4 base stations it can only operate on
one base station at a time.
To simplify the base station selection, rename your handset (default is "Philips").
(see “Renaming a handset”, page 48).
Go to the "SETTINGS" menu, then to the "Handset settings" sub-menu and
select "Select base" in order to activate the base station of your choice.
: If the selected base station is not active, your handset will look for the nearest
active base station.
2.7 Registering a handset to a base station
• Unplug the base station power cable and plug it back in.
A beep indicates that the base station switches to registration mode for 5 minutes.
Go to the "SETTINGS" menu, then to the "Handset settings" sub-menu and
select "Register".
The handset prompts you to enter your Pin.
• Enter the RC code printed on the back of the base station, then press the
key.
A confirmation signal beeps is heard.
zenia_anglais.book Page 40 Lundi, 28. janvier 2002 2:20 14