Filter
Top Products
Programmable Settings
16
Dialing Mode
If you have touch tone service, set to “Tone”. If rotary or pulse service is
used, set to “Pulse”. Your phone comes from the factory set to “Tone”.
Make sure the unit is not being used and the handset is lifted off the
base unit.
1
Press (MUTE/FUNCTION).
2
Scroll to “Initial set” by pressing Ö or
Ñ, and press á.
3
Scroll to “Set tel line” by pressing Ö
or Ñ, and press á.
4
Press á at “Set dial mode”.
•The current setting is displayed.
5
Select “Pulse” or “Tone” by pressing Ö or
Ñ.
6
Press á (Save key).
•A beep sounds.
•To exit the programming mode, press (OFF).
•You can exit the programming mode any time by pressing (OFF).
--------------
H
Save directory
Message play
Date and time
H
Initial set
--------------
Caller ID edit
H
Set tel line
Set answering
--------------
H
Set dial mode
Set flash time
Set dial mode
:Tone
GF H
=Save
Set dial mode
:Pulse
For Caller ID service users (p. 30)
•The Caller ID information will reset the clock after the first ring if the adjusted
time is incorrect.
•If the clock has not previously been set, the Caller ID information will not adjust
the clock.
•
The Caller ID information will automatically adjust the clock for daylight saving time.
To check the date/time
(MUTE/FUNCTION) \ Ö or Ñ to select “Date and time” \ á \
\ Ö (Next key) TWICE \ Date and time will be displayed. \ (OFF)
•When entering the time in step 6, you cannot enter numbers greater than 12. Do
not use military time. (To set 13:00 hours, enter “0100”, and select “PM” by
pressing (*).)