Filter
Top Products
Answering System
36
Caller’s recording time
You can change the maximum message
recording time allotted to each caller.
You can also select “Greeting Only”
which sets the unit to greet callers but
not record messages. The default
setting is “3 Minutes”.
1 K (middle soft key)
2 {V}/{^}: “Answer System” i
M
3 {V}/{^}: “Settings” i M
4 {V}/{^}: “Recording Time” i
M
5 {V}/{^}: Select the desired setting.
i M i {ih}
Note:
L You may create your own greeting-
only message by following the steps
on page 31.
The unit plays the pre-recorded
greeting-only message asking callers
to call again if your own greeting-only
message is not recorded.
Call screening
You can set the call screening feature
on/off. For details, see page 30.
The default setting is off.
To turn call screening on
Press and hold {■} until a long beep
sounds.
To turn call screening off
Press and hold {■} until a short beep
sounds.
The default setting is “On”.
1 K (middle soft key)
2 {V}/{^}: “Answer System” i
M
3 {V}/{^}: “Settings” i M
4 {V}/{^}: “Call Screening” i
M
5 {V}/{^}: Select the desired setting.
i M i {i h}
Base unit
Handset
TG7341NZ(e).book Page 36 Wednesday, September 3, 2008 11:37 AM