Filter
Top Products
Programmable Settings
For assistance, please visit http://www.panasonic.com/consumersupport 45
2 Scroll to “Accessibility” by
pressing {V} or {^}, then press
{Select}.
3 Scroll to “Hearing Aid Mode” by
pressing {V} or {^}, then press
{Select}.
4 Select “Telecoil” or “Off” by
pressing {V} or {^}.
5 Press {Save}, then press {OFF}.
Note:
LWhen “Telecoil” is selected, “[HA]” is
displayed after you press {C}.
LIf “Telecoil” is selected, the battery
operating time will be shortened
(page 10).
LIf “Telecoil” is selected, the cordless
handset receiver may feel warm during
use. This is normal.
Re-registering the handset
If “No link to base. Move closer
to base, try again.” is displayed
even when the handset is near the base
unit, you may need to re-register the
handset to the base unit.
Important:
LMake sure the base unit is not being
used.
LHave the handset and base unit near
each other when re-registering the
handset.
LFollow steps 1 and 2 listed below. You
have about 1 minute to complete them.
1 Base unit:
Press and hold {LOCATOR/
INTERCOM} until a beep sounds.
LThe CHARGE indicator flashes.
2 Handset:
Press and hold {FLASH/CALL WAIT}
until “Handset Registering” is
displayed
.
LWhen registration is complete, a
beep sounds from the handset.
LWait for 20 seconds after
registration is complete while the
handset establishes
communication with the base unit.
Note:
LIf the handset beeps 3 times and
“Error!!” is displayed, an error
occurred. Try again from step 1.
LYou can stop registration by pressing
{OFF} on the handset, and pressing
{LOCATOR/INTERCOM} on the base
unit.
Talk
00-00-32 [HA]