Filter
Top Products
Programmable Settings
36 For assistance, please visit http://www.panasonic.com/consumersupport
Programming via direct commands
You can also program features using “direct commands”—special codes that take you
directly to the feature you wish to program and allow you to select the desired setting.
There is no need to scroll through the unit’s menus.
Details of each feature can be found on the corresponding pages.
Important:
LBefore programming, make sure the handset and base unit are not being used. The
handset must be operated near the base unit and while off the base unit or charger.
1 Press {MENU}.
2 Enter the desired feature code (page 37).
3 Enter the desired setting code (page 37).
LThis step may vary depending on the feature being programmed.
4 Press {Save}.
5 Press {OFF} to exit programming mode.
Note:
LIf you make a mistake or enter the wrong code, press {OFF} then start again by
pressing {MENU}.
Initial setting Set answering Number of rings 54
Recording time 54
Remote code 54
Recording mode 55
Message alert —55
LCD contrast —41
Key tone —42
Auto talk —43
Caller ID edit —42
Set tel line Set dial mode 15
Set flash time 43
Set line mode 43
Set base unit Ringer tone 40
Incoming call. 40
Talk Caller ID 41
Change language —14
Main menu Sub-menu 1 Sub-menu 2 Page