Filter
Top Products
Chapter 6
Useful Information
57
Replacing the Batteries
Battery replacement
If “ ” flashes after a few telephone calls even when the handset batteries have been fully
charged, it is time to replace the batteries with new ones. Remember to charge the new batteries
after replacement.
1 Turn the power OFF to prevent memory loss (p. 13).
Remove the cover by sliding while pressing in the
direction of the arrow, then take out the batteries.
2 Replace the batteries with new ones as shown.
•When you finish, close the handset cover and turn
the power ON (p. 13).
3 Be sure to charge the new batteries fully in order to
display the battery icon correctly (p. 12).
Ni-Cd battery: For about 4 hours.
Ni-MH battery: For about 8 hours.
•Discard defective batteries as soon as possible. Defective batteries may leak into the unit.
•Please use only Panasonic P-03H or P-P03S batteries.
•If the rechargeable batteries are not inserted correctly, the handset will not work.
•Nickel metal hydride (Ni-MH) rechargeable batteries (AAA size) are available. Please use only
Panasonic HHR-P03H batteries.
•Please return the rechargeable batteries to your sales shop at the end of their useful life.
Selecting the battery type
Three Nickel cadmium (Ni-Cd) batteries are included with this unit. Nickel metal hydride (Ni-MH)
rechargeable batteries can also be used. If you replace the batteries with Ni-MH batteries, you must
set the battery type selection to “1”, or the battery strength will not be displayed correctly.The factory
preset is “0” (Ni-Cd).
1 Press .
2 Press G or F until “
F33
” is displayed.
3 Press .
4 To select Ni-MH batteries, press .
OR
To select Ni-Cd batteries, press .
5 Press .
•A confirmation tone sunds and the display will return to the stand-by mode.
•Incorrect battery type selection may shorten battery life.
0
1
OK
KX-TCD961CXB(57~68) 99.12.3 2:22 PM Page 57