Filter
Top Products
30
Direct Call
You can easily make a call using a stored direct call number by pressing . Incoming calls are
accepted.
Setting the Direct Call Mode
After storing the direct call number, the unit will automatically switch to the direct call mode.
When the direct call mode is on, you can ONLY dial the number stored in the direct call memory.
1 Press .
2 Press G or F until “
F42
” is displayed.
3 Press .
•If the current stored number is the same
as the number you wish to set, skip to
step 5.
4 Enter the phone number, up to 24 digits.
•If you misdial, press . The digits are
erased from the right. To erase all digits,
press firmly.
5 Press .
•A confirmation tone sounds.
•The display will return to the stand-by
mode, then “ ” is displayed.
C
C
OK
To change the direct call number:
Enter the new direct call number in step 4.
To turn OFF the direct call mode
1 Press .
2 Press G or F until “
F42
” is displayed.
3 Press .
4 Press .
•“ ” will go out.
OK
Dialing the Stored Number
Make sure that “ ” is displayed, then press .
•The number stored in the direct call memory is dialed automatically.
F42 -
-i-
KX-TCD961CXB(28~33) 99.12.3 2:15 PM Page 30