Panasonic KX-TCD961CXB Telephone User Manual


 
Cordless Telephone (Advanced Operations)
Chapter 3
37
Clearing the Settings in Memory
This function enables the handset or base unit to clear the following settings at one time. They will
return to their initial settings.
Base unit access Automatic base
unit access
Key tones ON
Handset ringer volume 3 (MEDIUM)
Handset ringer pattern 1
Call waiting tone ON
Range warning alarm OFF
Battery low alarm ON
Stand-by mode display Base unit number
Talk mode display Length of the call
Call prohibition OFF
Direct call mode OFF
Direct call number Clear
Handset password 0000
Handset receiver volume MEDIUM
Redial memory All clear
Function
Initial setting
On the handset
On the base unit
1 Press .
2 Press G or F until “
F0
is displayed,
then press .
3 Enter the handset password (p. 29).
4 Press .
A confirmation tone sounds and the
display will return to the stand-by mode.
OK
1 Press then .
2 Press .
3 Enter the base unit password (p. 29).
4 Press .
A confirmation tone sounds and the
display will return to the stand-by mode.
0
INT
------------
------------
Function
Initial setting
Bell selection All handsets
Dialing mode Tone
Pause timing 3 seconds
Carrier code Clear
Area code(s) Clear
Call restricted handset(s) All clear
Call restriction number(s) All clear
Base unit password 0000
Base unit ringer volume 2 (MEDIUM)
Base unit ringer pattern 1
KX-TCD961CXB(34~37) 99.12.3 2:17 PM Page 37