Panasonic KW-WP1050E Telephone User Manual


 
Getting Started
58 Helpline Tel. No.: U.K. 0844 844 3898
Initialization Setup:
Problem Solution
Initialization Setup is not
displayed.
LDialogue boxes may not be displayed immediately due
to the state of the LAN.
LCheck that the LAN or WIRELESS indicator lights in
green. Also, check if the LAN card or wireless LAN card
is on. If not, check that the LAN is connected.
LCheck that the power supply was turned on in the
following order: modem, router (if you have one), base
unit, computer. When turning off the power supply, do
so in the following order: modem, base unit, router (if
you have one), computer.
I cannot find the IP
address assigned to the
base unit on LAN side
after restarting the base
unit in [AP-DHCP] mode.
LIP address of the base unit on LAN side changes from
the default IP address (192.168.102.1), after you restart
the base unit in [AP-DHCP] mode.
LThe handset shows the new IP address assigned to the
base unit on LAN side. See “View wireless network
status” on page 110.
The Initialization Setup
still indicates hotel mode
after switching the mode
selector to home mode.
LTo make the new mode effective, restart the base unit
(page 192) after the mode selector position is changed.
After failure to enter the
user name and the
password to a prompt
screen asking for them
for 3 times, the base unit
does not respond.
LWait for 1 minute until the base unit becomes ready and
access to http://192.168.102.1 (the base unit's default
IP address) or http://kxwpa.webpage
LOne minute interval is intentional to avoid malignant
access to the base unit.
WP1050E.book Page 58 Thursday, March 29, 2007 11:31 AM