Filter
Top Products
Base Unit Settings
140 Helpline Tel. No.: U.K. 0844 844 3898
3 Select the connection mode, then click [Next>].
4 Configure the connection mode you select in step 3, then click [Next>].
LSee “Configuring the Internet connection settings” on page 51 for instructions.
5 Confirm the settings you are about to save, then click [Save].
6 Click [Restart].
LThe settings that you have just configured are saved as profile No. 1 (HOME mode)
or No. 2 (HOTEL mode) according to the position of the Mode selector. The profile is
automatically named “Automatic generation” and saved.
LIf you click [Default Profile], you can revert the WAN side setting back to default
setting (DHCP).
If you have no specific instructions for the Internet connection from the hotel front
desk, use [Default Profile] for an easy setup.
LWhen you click [Refresh], the Internet connection status is refreshed.
LWhen PPPoE is selected in the Connection Mode, [PPPoE Connect] and
[PPPoE Disconnect] are available. You can connect PPPoE by clicking
[PPPoE Connect] and disconnect PPPoE by clicking [PPPoE Disconnect].
Modifying the existing network connection profile
1 Click [Network Connection] on the Top Menu.
2 Click [Modify] under the Network Connection heading.
WP1050E.book Page 140 Thursday, March 29, 2007 11:31 AM