Filter
Top Products
Introduction
Helpline Tel. No.: U.K. 0844 844 3898 27
WAN Green/
Amber
A short
blinking in
Amber and
a long
flash in
Green
An Internet connection has been
established using the Temporary LAN side
network settings.
LDuring this time, Port Forwarding, DMZ,
Packet Filtering and Static Routing
features are disabled. To re-activate
these features, change the LAN network
settings.
Alternate
flashing
The networks on the LAN and WAN sides
overlap and the connection to the WAN
side of the base unit is terminated.
LThe network configuration of the LAN
needs to be temporarily changed to
avoid an overlap of the LAN and WAN
networks.
Amber On An Internet connection has not yet to be
established (No IP address obtained).
Flashing The base unit firmware may be defective
and requires a firmware update.
LSee “Downloading the version-up
firmware to your computer for recovering
the base unit” (page 202).
Red Flashing The base unit hardware may be defective.
LVisit:
http://www.panasonic.co.uk
Off – The Ethernet cable is not connected to the
WAN port on the rear of the base unit.
Indicator
type
Indicator
colour
Indicator
pattern
Status
WP1050E.book Page 27 Thursday, March 29, 2007 11:31 AM