Panasonic KW-WP1050E Telephone User Manual


 
Handset Locator and Registration
136 Helpline Tel. No.: U.K. 0844 844 3898
Registering the handset
The handset and the base unit are preregistered. If for some reason the handset is not
registered to the base unit, after you change the base unit’s wireless settings (page 171),
or after you reset all the handset settings (page 126), register the handset. The handset
and the base unit need to be closely located during the registration.
1 {Menu} (middle soft key)
2 Settingsi {Select}
3 Phone settingsi {Select}
4 Registrationi {Select}
5 HS registrationi {Select}
6 Press and hold the LOCATOR button on the base unit for 4 seconds until you see the
LOCATOR Indicator on the base unit flashing in green. i {OK}
LThe registration starts. The status message changes from “Handset
registering” to “Handset registered”.
Note:
LIn step 5, select “Information” to view the network name and BSSID (the MAC
address) information for the base unit. i {Select}
LWhen the handset registration fails, the status message “Handset could not
register. Please try again.” is displayed. Press {OK}. Try step 6 again.
LYou can register only 1 handset to the base unit. Therefore, if you register another
handset to the base unit, the previously registered handset cannot be connected to the
base unit.
LWhile the handset is being registered, the LOCATOR indicator on the base unit flashes.
LOCATOR button
LOCATOR indicator
WP1050E.book Page 136 Thursday, March 29, 2007 11:31 AM