Filter
Top Products
39
Testing the System
You can check the system for proper operation. Before testing the system, you
must disarm the security mode and close all protected windows, doors, etc.
Refer to “Testing the System (To Be Conducted Weekly)” on pages 39 to 40 in the
3000EN Security Systems User’s Guide.
Make sure all perimeter doors and windows are closed and is
displayed.
: Press the soft key ( ), and follow steps 2 to 6 above, using
the cordless handset. Press [OFF] to go to the standby mode.
1 Press [ADT].
2 Scroll to “TEST” by pressing [
d
] or [
B
], then
press [
g
].
3 Enter your security code.
• If you entered the wrong security code, the phone
will go back to the previous display. Try again from
step 2.
4 Press [0].
•“1=Dial” is intended for the installer.
• To remind you that the system is in the test mode,
a beep sounds at regular intervals.
• When the door or window is closed, the display
clears.
5 Open each protected door or window, listen to
the chime and confirm the zone number/zone
description on the display.
6 To exit the Test mode, press [
g
] while
“
=Abort Test” is displayed, then enter your
security code.
7 Press [STOP] to go to the standby mode.
READY
Base Unit
TEST
g
ENTER CODE
----
1=Dial, 0=Walk
Example
Test In Progress
=Abort Test
g
g
ENTER CODE
----
Handset
ADT
SecurityPhone.book 39 ページ ２００４年７月２１日 水曜日 午後６時５８分