20
PANIC Keys
The PANIC keys can manually activate emergency (panic) functions, and send
signals to the Customer Monitoring Center, if the system is being monitored.
Using the PANIC Keys
If the PANIC key is pressed while a phone is in use, the operation of a phone is
cancelled.
Press and hold the required PANIC keys
for two seconds.
1 Press the soft key ( ).
2 Press and hold the soft key (FIRE, POLICE or
MED.) until an alarm sounds.
• ADT monitoring service must be in effect!
To stop and clear a fire alarm
1
Enter the security code.
OR
Press [1].
• If the system is armed, the system becomes disarmed.
• Alarm stops.
• Check the zone (the zone will be shown on the display). Make sure that it is
intact.
2 Press [ADT].
3 Enter your security code, then press [1].
• Alarm display will be cleared. If the display is not cleared, try again.
4 Press [STOP] to go to the standby mode.
Base Unit
PANIC keys
(FIRE, POLICE, MED.)
Emergency Select
FIRE POLICE MED.
ADT
PANIC PLAY
Handset
PANIC
SecurityPhone.book 20 ページ 2004年7月21日 水曜日 午後6時58分