Filter
Top Products
31
SD Memory Card/MultiMedia Card
Inserting/Removing an SD Memory Card/MultiMedia Card
An SD memory card/MultiMedia Card can be used for the following purposes.
The exchange of data with various devices equipped with an SD memory card/MultiMedia
Card slot, audio storage, and so on.
1
Open the SD memory card/MultiMedia Card slot
cover.
2
Inserting
Slide the card in until it snaps into place as shown in the
illustration.
Make sure the labeled face of the SD memory card/
MultiMedia Card is towards the front of the computer and
then firmly insert the card. If you mistake the back side of
the card with the top surface side, the card cannot be in-
serted all the way into the slot.
Do not insert the card at an angle.
Insert the card all the way into the slot.
Removing
(1) Press the card. It will come out slightly.
(2) Remove the card.
3
Close the SD memory card/MultiMedia Card slot
cover.
NOTE
Software (e.g., drivers) required to exchange data with these devices. (Refer to the
instructions manual provided with each SD compatible peripheral device.)
Use as a memory card (e.g., use as a storage unit on which files can be written).
CAUTION
Before removing an SD memory card/MultiMedia Card or powering off CF-P1, check to
see if CF-P1 is trying to access the card. Such accesses are done intermittently for a short
period of time. Be sure to remove the card or power off CF-P1 only after confirming that
CF-P1 is not trying to access the card. If the card is removed or CF-P1 is powered off
during an access attempt, valuable data may be lost or CF-P1 may fail to work properly.
SD Memory Card/
MultiMedia Card Slot