Filter
Top Products
44
Dealing with Problems
Troubleshooting
Starting Up
Check to see if a fully charged battery pack is properly
installed.
The power does not go on unless the AC adaptor is con-
nected:
The battery level is too low. Charge the battery with the
AC adaptor. (Make sure that the battery never discharges
completely and that it is charged periodically.)
Push the reset switch to restart CF-P1.
Slide the latch to lock the
battery pack cover all the
way to the left.
If the power does not turn on when the above operations
are performed, the battery pack must be replaced.
You can set the date and time through [Clock] in
- [Settings] - [System] tab.
If you continue to experience problems, the backup
battery maintaining the clock may need to be replaced.
Contact Panasonic Technical Support.
This computer will not correctly recognize the date and
time starting from the year 2085 A.D.
The battery level may be too low. If the battery level
goes below a certain threshold, CF-P1 automatically shuts
down. In such cases, connect the AC adaptor and charge
the battery.
The computer may have entered a locked state. If this is
the case, connect the AC adaptor and push the reset
switch. Check the remaining battery level and make sure
that multiple applications are not running simultaneously.
Close all applications that are not being used.
The computer may be turned off automatically while the
data is being copied by beams or when using File Ex-
plorer. To prevent this, change the time setting to a longer
time in - [Settings] - [System] tab - [Power] - [Ad-
vanced] tab.
It is possible that you were using 10 MB or more of stor-
age memory, and that the power was turned off soon af-
ter making settings. In this case, wait a few minutes be-
fore turning off the computer.
CF-P1 does not turn on.
Or, there is no display
when CF-P1 is turned on.
The date and time are in-
correct.
CF-P1 shuts down auto-
matically.
The data cannot be copied.
Alarm and Auto backup do
not operate according to
settings.
Latch