Filter
Top Products
24 First time installation of the IP Phone 1535
Physically install the IP Phone 1535
Basic installation of the IP Phone 1535 consists of connecting to the correct
ports using the appropriate cables. Make the physical connections for the
handset and power, as well as attach the IP Phone 1535 to the included
telephone stand, by following the procedures in the following sections.
Installation guidelines
Consider the following conditions when you choose a location in which to
install the IP Phone 1535:
•
Use the IP Phone 1535 in an environment with a temperature range of
+0
to 40
C and a relative humidity of 5 to 95 percent.
•
Place the IP Phone 1535 on a smooth, nonslip surface.
•
Do not install the IP Phone 1535 in a dusty environment; dust deposits
can adversely affect moving parts.
• Do not install the IP Phone 1535 in a location directly exposed to
sunlight or radiant heat sources; these can cause damage to electrical
components.
•
The IP Phone 1535 does not support Power Over Ethernet (PoE);
therefore, do not install the phone on a PoE configuration.
Connect the handset
Step Action
1
Insert one end of the coiled cord into the handset connector port.
This port is on the handset cradle side of the IP Phone 1535.
2
Insert the other end of the coil cord into the port on the handset.
—End—
Connect the IP Phone 1535 to a power source
WARNING
Use only the power adapter supplied with the IP Phone 1535,
as other adapters can cause operating anomalies, hazardous
conditions, and material damage.
Step Action
1
Insert the power adapter DC plug into the DC power jack, at the rear
of the IP Phone 1535 phone base.
Nortel Communications Servers
Nortel IP Phone 1535 Installation and Commissioning
NN43160-300 02.03 Standard
Release 4.0/SN10 28 October 2009
Copyright © 2009, Nortel Networks
.