Filter
Top Products
Technical Configuration (T1/E1) MultiVOIP User Guide
124
Local Configuration
This manual primarily describes local configuration with the Windows
GUI. After IP addresses have been set locally using the Windows GUI,
however, most aspects of configuration (logging functions are an
exception) can be handled through the web browser GUI, as well (see
the Operation and Maintenance chapter of this manual). In most aspects
of configuration, the Windows GUI and web-browser GUI differ only
graphically, not functionally. For information on SNMP remote
configuration and management, see the MultiVoipManager
documentation.
Pre-Requisites
To complete the configuration of the
MultiVOIP unit, you must know several
things about the overall system.
Before configuring your MultiVOIP Gateway unit, you must know the
values for several IP and T1/E1 parameters that describe the IP
network system and telephony system (PBX or telco central office
equipment) with which the digital MultiVOIP will interact. If you plan
to receive log reports on phone traffic by email (SMTP), you must
arrange to have an email address assigned to the VOIP unit on the
email server on your IP network.
IP Parameters
The following parameters must be known about the network (LAN,
WAN, Internet, etc.) to which the MultiVOIP will connect:
9
Ask your computer network
administrator.
Info needed to operate:
all MultiVOIP models.
IP Network Parameters:
Record for each VOIP Site
in System
#
•
IP Address
•
IP Mask
•
Gateway
•
Domain Name Server (DNS) Info
(not implemented; for future use)