Filter
Top Products
- 84 -
Alerting Tones and LEDs
The cordless accessories provide the following alerting tones:
Feature
Function
Mute key on cordless device
ON/OFF
2-pitch tone occurs immediately. Reminder tone occurs 30
seconds after activation and then regularly until deactivated.
Mute key on Phone ON/OFF
No immediate tone. Reminder tone occurs 30 seconds after
activation and then regularly until deactivated.
Low battery (within 10 minutes left)
3 beeps and 20 second pause repeated 3 times
Low battery (within 2 minutes left)
3 rapid beeps and 1.5 second pause repeated 3 times
Out of range
Repetitive 3-pitch tone until you are back in range. Note: If you
are out of range for more than 10 seconds, any call that is in
progress is dropped and not recovered.
Note: Audio indications are heard in the handset only when it is in use and may interrupt
voice transmission.
Cordless Handset LEDs
The handset has two LEDs:
Blue – indicates the operational status of the handset
Green – indicates the status of the electrical charge of the battery
LED
Color
LED State
Indicates
Blue
Solid
Handset is muted
Blinking
Handset is in pairing mode
Winking
Active audio path between Handset and Module
Off
No audio path between Handset and Module OR
Battery is dead
Green
Solid
Battery is fully charged
Blinking
Battery is charging. Note: It is normal for the handset LED to cycle
between blinking and solid as battery charge is maintained.
Off
When handset is cradled and the LED does not flash or illuminate, this
indicates an absence of battery power. During the first 30 – 60 minutes
that the light is off, the battery may be trickle charging. If that is the
case, the LED will resume normal behavior within that 60 minute period.
If the LED remains off for more than 60 minutes, then either the battery
is no longer chargeable or there is a problem in the charging circuit.
Blinking: LED is On and Off for equal amount of time
Winking: LED is On for a short period of time and Off for a longer period