Filter
Top Products
4-11
Linksys IP Phone Administrator Guide
Firmware Version 5.1
Chapter 4 SPA900 Series LCD Command Reference
9 Network
9.5 Current NetMask
Shortcut: Setup, 9, 5 save
To view the Current NetMask, press 5 from the Network menu, or scroll down to highlight NetMask
and press the select soft key. The Current NetMask is set in one of the following ways:
• Receive the address from a DHCP server by enabling DHCP (option 9.1)
• Manually set the address using the Non DHCP Subnet Mask option (Option 9.9)
9.6 Current Gateway
Shortcut: Setup, 9, 6 save
To view the Current Gateway, press 6 on the Network menu, or scroll down to highlight Current
Gateway and press the select soft key.
The Current Gateway is set in one of the following ways:
• Receive the address from a DHCP server (you cannot edit it)
• Manually set the address using the Non DHCP Default Route option (Option 9.10)
9.7 Enable Web Server
Shortcut: Setup, 9, 7, y/n, ok
To view the status of the Web Server, press 7 from the Network menu, or scroll down to highlight
Enable Web Server and press the select soft key. To enable or disable the Web Server, press the edit
soft key. Press the y/n soft key to toggle between Yes to No and press ok.
9.8 Non DHCP IP Address
Shortcut: Setup, 9, 8, ip_address, ok
To manually set the IP address, press 8 from the Network menu, or scroll down to highlight Non DHCP
IP Address and press the select soft key. Then press the edit soft key. The display shows the option to
enter an IP address. enter the IP address here. This IP address is always used by the phone (it is a static
IP address). After entering IP address, press ok.
9.9 Non DHCP Subnet Mask
Shortcut: Setup, 9, 9, subnet_mask, ok
To manually set the subnet mask, press 9 from the Network menu, or scroll down to highlight Non
DHCP Subnet Mask and press the select soft key. Then press the edit soft key. After entering the subnet
mask, press ok.
9.10 Non DHCP Default Route
Shortcut: Setup, 9, 10, ip_address, ok
To edit the default gateway (router), press 10 or scroll down to highlight Non DHCP Default Route and
press the select soft key. Then press the edit soft key. After entering the default route, press ok..