Filter
Top Products
22
PPN 92
92#92#
DELETE ALL DIRECTORY ENTRIES
PPN 200
200#000000#000000#
TOTAL MEMORY RESET
PPN 37
37#POLL RESULT
POLL RESULT = DISPLAY OF SUB-UNIT NUMBERS
THAT RESPONDED WITH NO ERRORS ON THE FIRST TRY
POLL SUB-UNITS
PPN 83
83#
RELEASE ACCESS RELAY
PPN 73
73#INFO
INFO = DISPLAY OF SYSTEM FIRMWARE VERSION
DISPLAY SYSTEM INFORMATION
PPN 80
80#HOURS#
HOURS = RELAY LATCH TIME IN HOURS (01-98)
TIMED ACCESS RELAY LATCH
PPN 81
81#
LATCH ACCESS RELAY
PPN 93
93#93#
DELETE ALL STAND-ALONE ENTRY CODES
STANDARD PROGRAMMING METHOD
System Utility Commands (Continued)
Poll Sub-units
In multi-unit installations, this utility command will instruct the master
unit to poll the sub-units (request and receive communications). This
command is used for testing purposes only.
1. Press
2. The display will show the unit numbers that responded on the fi rst try error free.
3. Enter another programming step number followed by
or press
to exit.
Display System Information
The version of the fi rmware installed in the AE-100 can be displayed.
✦ NOTE: This step cannot be performed remotely through the telephone.
1. Press
2. The display will show the fi rmware version.
3. Press
to exit.
Timed Access Relay Latch
For servicing or testing, while in Programming Mode, the access relay
can be latched manually from the keypad for a period of hours.
1. Press
2. Enter the amount of time in hours (01-98) for the access relay to latch.
3. Press
Latch Access Relay
For servicing or testing, while in Programming Mode, the access relay
can be latched manually from the keypad for an indefi nite period of time.
✦ NOTE: This command will reset and override and timed access relay latch
set by PPN 80.
1. Press
Release Access Relay
For servicing or testing, while in Programming Mode, this command
will release the access relay if it has been manually latched (timed or
indefi nite).
1. Press
Delete All Directory Entries
This utility command will permanently erase all Directory Codes, Names,
Telephone Numbers, and resident’s Entry Codes.
CAUTION: This utility command will erase all the Directory Entries in the unit.
✦ NOTE: This step cannot be performed remotely through the telephone.
1. Press
2. Press
again for verifi cation.
Delete All Stand-alone Entry Codes
This utility command will permanently erase all Stand-alone Entry
Codes.
CAUTION: This utility command will erase ALL the Stand-alone Entry
Codes in the unit.
✦ NOTE: This step cannot be performed remotely through the telephone.
1. Press
2. Press
again for verifi cation.
Total Memory Reset
This command will erase all data and restore the factory settings.
CAUTION: This utility command will erase ALL the data in the unit.
✦ NOTE: This step cannot be performed remotely through the telephone.
1. Press:
2. Press:
3. Press:
again for verifi cation.