Filter
Top Products
24
M A S T E R C O D E :
E N T E R D I R :
E N T E R N A M E :
D i r # i s u s e d !
E R R O R D A T A
T E L E P H O N E # :
A C C E S S C O D E :
ALTERNATE PROGRAMMING METHOD
Alternate Programming Reference
Refer to the following pages when programming using the Alternate
Programming method.
For each of the following steps, enter the Master Password and enter
Programming Mode (if the unit is not already in that mode). Exit
Programming Mode when all programming is complete.
FUNCTION CODE LOCAL PROGRAMMING TELEPHONE PROGRAMMING
00
REPLACE SYSTEM
MASTER CODE
(Default Setting is 123456)
Master Code is used to log into
programming mode, not to unlock
door or gate.
Step 1 Enter Function Code 00, then press #
Step 2 Enter the new 6-digit Master Code
Step 3 Press #
Step 1 Enter Function Code 00 and
press #, one short beep sounds.
Step 2 Enter the new Master Code.
Step 3 Press #, two short beeps sound.
01
PROGRAM A NEW
TENANT
There are four different fi elds
that need to be programmed:
Directory Code, Name, Telephone
Number, and Access Code.
Directory Code: A unique 2 or
3 digit code assigned to each
tenant for identifi cation.
Name: Up to 16 characters.
Telephone Number: Up to 14
digits.
Access Code: 4-digit code
assigned to tenant for obtaining
access with the keypad.
NOTES:
1. Directory Codes can be set
for 2 or 3 digits. All Directory
Codes will be the same length.
2. A Directory Code cannot be
duplicated.
3. Each Directory Code
represents one tenant.
4. Delete unused Directory Codes
to avoid running out of memory.
5. Tenant Names can be entered
in any order. The system
will display the Names in
alphabetical order.
6. The same Name, Telephone
Number, and Access Code can
exist with different Directory
Codes.
Step 1 Enter Function Code 01, then press #.
Step 2 Enter the new 2 or 3 digit Directory Code.
Proceed to Step 3.
If the Directory Code has already
been used the display shows:
Return to Step 2.
If the memory is full the display shows:
Return to Step 2.
Step 3 Enter the tenant Name (up to 16
characters), press # after each character,
then # again after the last character.
Step 4 Enter the tenant’s Telephone Number (up
to 14 digits), press # after each number, then #
again after the last number. Press and
hold down the 1, 2, 3, or 4 key for about two
seconds to enter 1-4 two second pauses. Note:
Each pause entered counts as one of the 14
digits.
Step 5 Enter the 4-digit Access Code,
Step 6 Press #.
Step 1 Enter Function Code 01 and
press #, one short beep sounds.
Step 2 Enter the new Directory Code (2 or 3
digits) and press #, one short beep sounds.
(If you hear two long beeps, the Directory
Number already exists, return to Step 1.)
Step 3 Enter the Name (up to 16 characters)
press # after each character, then
# again after the last character,
one short beep sounds.
Step 4 Enter Telephone Number (up to 14
digits), press # after each number,
then # again after the last number and
press #, one short beep sounds.
Step 5 Enter the 4-digit Access Code, then
press #, two short beeps sound.