Filter
Top Products
51
PTT ID
PTT ID is the transceiver unique ID code which sent each
time the PTT switch is pressed.
Note: PTT ID can be made only in FM Operation.
If Beginning of Transmit is set, the ID signal is transmitted
when you press the PTT switch.
If End of Transmit is set, the ID signal is transmitted when you
release the PTT switch.
If both are set, the ID signal is transmitted when you press
and release the PTT switch.
BUSY CHANNEL LOCKOUT (BCL)
If set up by your dealer, you will be unable to transmit on a
conventional channel if it is already in use. Under these
circumstances, use a different channel or wait until the
channel becomes free.
However, if BCL Override has also been programmed, you
can transmit overtop of the current signal:
1 Press and hold the PTT switch.
• If the channel is already in use, a warning tone will sound.
2 Release the PTT switch, then press and hold the PTT
switch again within half a second.
3 Speak into the transceiver as you would during a normal
transmission.