Filter
Top Products
34
SELECTING THE ENCRYPTION KEY
1 Press the key programmed as Scrambler/ Encryption
Code (K2 and K3 Models Only) or press and hold the key
programmed as Scrambler/ Encryption for 1 second, to
enter Key Selection Mode.
2 Select the new Encryption key using the Side 2 and Side
3 keys or the <C and D> keys.
• There are 16 available Encryption keys (1 ~ 16).
• Each group member must select a key that is in each
member’s key list in order for the transceivers to descramble
the received signals.
3 Press the Side 1 key to set the new Encryption key.
Note: To return the transceiver to the default Encryption key
programmed, select “PRESET”. However, if you delete the
Encryption key (see below), it will not be recovered.
DELETING THE ENCRYPTION KEY (K2 AND K3 MODELS ONLY)
1 Press the key programmed as Key Delete to enter Key
Delete mode.
2 Select the current Encryption key using the Side 2 and
Side 3 keys or the <C and D> keys.
3 Press the B key to delete the Encryption key.
4 Press the Side 1 key to exit Key Delete mode.
Note: To delete all Encryption keys (when more than one key has
been set up), select “ALL”.
PASSWORD PROTECTION (K2 AND K3 MODELS ONLY)
If the transceiver is password protected, entering an incorrect
password successively 15 times will automatically delete all
the Encryption keys.
•Turning the transceiver power OFF and the ON again will not
reset the number of attempts for entering an incorrect password.