Filter
Top Products
41
• Channel Select
Using the selector, turn clockwise to increase the channel
number and counterclockwise to decrease the channel
number. If a channel has not been programmed, an error
tone will sound.
• Channel Up (CH▲)
Press this key to increase the channel number. Press and
hold this key to cycle up through the channel numbers.
When the highest channel number is reached, the
transceiver will “roll-over” to the lowest channel number
and continue cycling up.
• Clock (CLK)
Press this key to display the current time.
• Direct Channel 1 ~ 5 (DC1 ~ DC5)
Press one of the five Direct Channel keys to jump to a
frequently used zone and channel. The zones and
channels are programmed by your dealer.
If activated by your dealer, you can set your own Direct
Channels. First, select your desired zone and channel,
then press and hold the Direct Channel 1 ~ Direct
Channel 5 key for 3 seconds to set your selected zone
and channel as that Direct Channel.
• Display Character (CHR)
Press this key to switch the display between the zone and
channel number and the channel name (if a name has
been programmed).
• Emergency
Press and hold this key to enter Emergency mode. This
key is set up with a delay time to avoid accidentally
entering Emergency mode. The length of time you must
hold the key before entering Emergency mode depends on
the key setup. Refer to “EMERGENCY CALLS” on
page 32 for details.