Filter
Top Products
PPU Manpages
ppuconfig (1M) Manpage
Appendix D74
Options
ppuconfig recognizes the following command-line options and
arguments:
-m meter Specifies the utility meter that the Pay Per Use system
should use for reporting. The meter can be specified as
a fully qualified hostname or IP address. A non-blank
value is required.
-p proxy[:port] Specifies the proxy server that should be used by this
system for HTTPS transmission if a proxy server is
required. Optionally, a port number can be appended to
the proxy server specification. Proxy configuration can
be cleared by specifying an empty string (“”) as the
proxy server value.
-s system_id Specifies the system identifier that the Pay Per Use
system should use when reporting. This can be any
value that helps you to identify this system (for
example, a tracking number, asset number, physical
location, etc). Until a system identifier is specified, the
hostname will be used by default.
-h Specifies that the hostname should be used as the
system identifier for the Pay Per Use system, when
reporting usage information.
-u Starts an interactive session to allow setting a
username and password for the proxy server, if
required by the proxy server. These values can be
cleared by pressing
Enter when prompted for a
username.
-t Perform communication test between Pay Per Use
software and the configured utility meter.
RETURN VALUES
ppuconfig exits with one of these values:
0 Success.
>0 Failure; error message sent to STDERR