Filter
Top Products
Installing and Configuring PPU Software
Getting Started
Chapter 3 25
Step 3. Verify the ppud daemon is running on the system/partition by executing
the following command:
/usr/bin/ps -e | grep ppud
You should see the ppud daemon listed as an active process on the
system/partition.
If you do not receive the correct result for
Step 3 (above) see “Manually
Starting the ppud Daemon” on page 32 for details.
IMPORTANT You need to configure the PPU software so your PPU system/partition
communicates with the utility meter. PPU systems do not have the PPU
software configured at the HP factory. See “Configuring PPU Software”
on page 29 for details on configuring the utility meter settings.
If
Step 1, Step 2 and Step 3 (above) provide the correct results, your PPU
system is compliant and no action is necessary for PPU software
installation or configuration.